WELCOME TO Hongkong NKF Machinery Co.,Limited. English | Spanish

loose ball bearings

loose ball bearings
Author :Admin | Publish Date:2012-08-31 17:58:40
Keep a container next to you and put your "loose ball bearings" straight into it as you’re removing them from your hubs. They’re easy to lose and seem to like nothing better than rolling into hard-to-reach places, particularly under the fridge.


Get a magnetised screwdriver blade to make life easier for yourself when removing loose ball bearings from a hub – the balls bearings will stick to the magnetic tip without the need for more sticky grease. Either buy one or magnetise your own screwdriver by dragging its blade over a fridge magnet several times in the same direction.


We offers loose ball bearings at a price-per-piece option. Typically, each skf bearing will cost a few cents, and you can choose from a variety of sizes. Most products offered are generic and made to fit a variety of bicycle brands. They also offer a variety of front and rear hub bearings, also priced per piece.


We offers different grades, sizes and quantities of loose ball bearings. Quantities are typically priced low, and Jenson USA also offers a price-match guarantee. This means if you find the same product cheaper at another seller, Jenson USA will match or beat the price the other retailer is offering.


A cup and cone hub makes use of loose ball bearings and allows you to easily adjust bearing tension, unlike most sealed bearing hubs that don't allow for any adjustment. They consist of the "cup" that acts as the bearing's outer race, which is pressed into the hub shell and not replaceable, and the "cone" that serves as the inner race and threads onto the axle. The hub bearings, which are usually 1/4" in rear hubs and 3/16" in front hubs, spin between the cup and cone. timken Bearing tension is adjusted be threading the cone down on the axle, and then locking its position in place with the locknut (a spacer between the cone and locknut allows you to tighten the two against each other easily). Front cup and cone hubs are usually symmetrical, although the hub will be offset slightly to compensate for its rotor disc rotor mounting. Rear hubs use a freehub (the clutch mechanism that allows you to coast) and the driveside cone and locknut can be found set within, sometimes hidden from view.


Always use the smallest cone wrenches the fit. Most front hubs will accept either 13, 15 or 17mm sizes, while rear hubs often take 15, 17 and 19mm size wrenches. A crescent wrench can be used on the outer locknut. 


W211PP2
61989 C4

Contact Us

TEL:00852-54978621
FAX:00852-54979628
Email:sales@dbearings.com
Add:UNIT 04,7/F BRIGHT WAY TOWER,NO 33 MONG KOK ROAD,KL
WhatsApp:8618112377009

nsk information lists

Copyright © 2014 Hongkong NKF Machinery Co.,Limited. All rights reserved. TEL:00852-54978621 FAX:00852-54979628 Email:sales@dbearings.com