boat trailer bearings
Repacking auto bearings on boat trailer bearings is actually a typical maintenance challenge. Overlook this process and also you will be stranded beside the street when your wheel falls off! It really is not tough to repack the auto bearings over a little trailer with no brakes, as you don’t need to spine away the footwear or bleed the caliper.
I favor to complete it using the trailer connected on the truck, because it’s a smaller amount more likely to fall away the jack. Be cautious jacking up the trailer, and don’t get underneath it.
The prime picture is for dialup consumers, the big one under for broadband
Wiggle the wheel to generate the outer auto bearings shift out enough for yourself to grab it and pull it away from. Have a very clear rag or report towel to set it on and that means you don’t get filth in the auto bearings.
Get rid of internal bearing. Clean both equally auto bearings, which should be lined and impregnated with dirty grease. If you wipe off as very much from the grease off with report towels prior to you use solvent it usually requires incredibly tiny solvent to have them clear. Inspect the rollers for any pits or scars, in the event you see any at all go invest in new auto bearings, which include new outer races. Take on the clean outdated auto bearings and seals with you, so the elements area can match them. I actually don’t like to reuse the seals, as they support to maintain the water out after you launch your boat.
Clear all of the aged grease, dust and water through the inside with the hub. Occasionally there is really a lot of grease in there, so I spoon it out very first, then wipe the remainder out with rags or paper towels. Clean the axle away too, and don’t forget to thoroughly clean the surface in which the brand new grease seal will experience. Meticulously inspect the “races” within the hub for pits or scars, it should be silky smooth. If not, you will need new auto bearings and races
Repack the bearings with new grease. Basically, you placed a bit grease in your palm and mash or roll the bearing into it until eventually it’s gone in the bearing. Placed additional on your palm and repeat until you can no longer get the grease to go from your palm to the auto bearings.
